Ramco Fabricators, Inc.


STRUCTURAL BENDING:

Equipped with four angle rolls of various sizes, Ramco is one of a very few fabricators in the Southeast that has the ability to roll steel structural members, hard way and easy way, including angles, channels, rails, tees, bars, beams, pipe, and tubing.

STRUCTURAL BENDING CAPABILITIES

PIPE AND TUBE BENDING

ANGLES CHANNELS RAILS TEES BARS

LEG OUT
Specify inside diameter,
if unequal, which leg is out
BALL OUT
Specifiy inside diameter
EZ WAY
FLANGES OUT
Specify inside diameter
STEM OUT
Specify inside diameter
EZ WAY
Specify I.D. or O.D.

LEG IN
Specify outside diameter,
if unequal, which leg is in
EZ WAY
FLANGES IN
Specify outside diameter
BALL IN
Specify outside diameter
STEM IN
Specify outside diameter
HARD WAY
Specify I.D. or O.D.
BEAMS

HEEL OUT
Specify inside diameter
HARD WAY
OF WEB
Specify I.D. or O.D.
BALLUP
Specify die of web C/L
STEM UP
Specify die of stem C/L
EZ WAY
Specify die of web C/L

HEEL IN
Specify outside diameter
HARD WAY
Specify I.D. or O.D.

SPECIALTIES

CHANNELS: Flange Out & Flange in C3 up to MC18
Hard Way C3 up to C10
ANGLES: Leg In & Leg Out 1 1/2" up to 8"
RAILS: Ball Out, Ball In & Ball Up - Up to 175#
MONORAILS: Up to 24"
BEAMS: EZ-Way W4 to W24, S3 to S24
Hard Way Up to 12"
TEES: Stem Out 12", Stem In 15", Stem Up 12"
FLATBAR: Hard Way 1" to 12" Wide
PIPE: Up to 3"
TUBES: Up to 8" x 8"
PLATES: 14 Guage to 1 1/4" thick up to 120" Wide
Smallest Diameter - INQUIRE



Ramco Fabricators, Inc.
9501 West Market Street / P. O. Box 549
Colfax, NC 27235
(336) 996-6073
Fax: (336) 993-4692
email: ramco@ramcofabricators.com

© Copyrighted 1999, 2002 Stateside Data, Inc., All Rights Reserved